Thingiverse
Balloon for interior
by RUBOT_3D
62
Downloads
68
Likes
0
Makes
The task was to remove the antenna wires.
At first they wanted to clean the wall as usual.
But then they figured out how to close the antenna wires and make a cool design decision.
The balloon printed in parts (cut into Netfabb), then glued, polished, painted.
The holder is mounted on the wall.
The balloon is glued to the holder.
At first they wanted to clean the wall as usual.
But then they figured out how to close the antenna wires and make a cool design decision.
The balloon printed in parts (cut into Netfabb), then glued, polished, painted.
The holder is mounted on the wall.
The balloon is glued to the holder.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in