Thingiverse
Anet A8 X Axis Tensioner
by FredGenius
153
Downloads
83
Likes
2
Makes
This is an improved X axis tensioner and belt gripper, simply bolts onto the back of the x axis carriage using the existing holes.
The belt fits into the gripper slots, then you just tighten the slider screw to tension the belt. Simple.
You will need:
4x M3x18mm screws (use the two that are currently holding the belt, should be a few more left over from the build).
1x M4x30mm screw.
1x M4 half nut.
The belt fits into the gripper slots, then you just tighten the slider screw to tension the belt. Simple.
You will need:
4x M3x18mm screws (use the two that are currently holding the belt, should be a few more left over from the build).
1x M4x30mm screw.
1x M4 half nut.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in