Thingiverse
Sturdy Accessory Holder for Dyson V7 V8 V9 V10 V11
by xyzaxis
163
Downloads
88
Likes
2
Makes
Sturdy accessory holder for Dyson V7 / V8 / V9 / V10 / V11 vacuums. (Dyson V6 accessories use a different connector and will not fit.)
Works just like the factory dual accessory holder that's built into the charging station - snap in your accessories from underneath, and release it just like you were removing the tool from the vacuum. The intended mounting position is flat side up, with the two side mounting holes above the single center mounting hole. With some good wall anchors, this will h
Works just like the factory dual accessory holder that's built into the charging station - snap in your accessories from underneath, and release it just like you were removing the tool from the vacuum. The intended mounting position is flat side up, with the two side mounting holes above the single center mounting hole. With some good wall anchors, this will h
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in