Thingiverse
Mini Tricopter: Another Tail and Battery-Cover
by altermac
16
Downloads
11
Likes
0
Makes
Because I had only M3 30mm available and my servo did'nt fit, I designed a (almost) new Tail. Made it from scratch with OpenSCAD.
The motor-mount is made for 1806 or 2204 motors. Use only 2 screws with the motor, you can turn the motor with the other holes to point the cables towards the body.
The tail works with a Towerpro SG90 (analog or digital) wich is one of the lightest and cheapest servos you can get. You can also use SG92R, MG90S or MG90D. The tail-arm is made for fast servo change
The motor-mount is made for 1806 or 2204 motors. Use only 2 screws with the motor, you can turn the motor with the other holes to point the cables towards the body.
The tail works with a Towerpro SG90 (analog or digital) wich is one of the lightest and cheapest servos you can get. You can also use SG92R, MG90S or MG90D. The tail-arm is made for fast servo change
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in