Thingiverse
spring (6.2mm inner, 9mm outer, 10mm height, with rings at top and bottom)
50
Downloads
47
Likes
1
Makes
made this remix so it's smaller and has a top and bottom ring.
print it really slow (I printed 1500mm/sec) and quite cold (I did 185 instead of my usual 195-200 for PLA), or else you never build in height, it just droops. Also, make certain the layers are as thin as possible, or else the hangovers are going to be bigger the thicker the layer. I did .15mm and that was too much. go as small as your printer allows for something this small.
should scale up well, probably not down though, it'
print it really slow (I printed 1500mm/sec) and quite cold (I did 185 instead of my usual 195-200 for PLA), or else you never build in height, it just droops. Also, make certain the layers are as thin as possible, or else the hangovers are going to be bigger the thicker the layer. I did .15mm and that was too much. go as small as your printer allows for something this small.
should scale up well, probably not down though, it'
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in