Utah tea cup and saucer

Cup and saucer based on data from:
http://www.holmes3d.net/graphics/teapot/

I scaled the height down to 0.75 to match the Utah Teapot.

2014-03-13:
Ive scaled up the size since I first uploaded as you could pour 12 cups from one teapot

still a bit hard to print the bottom of the handle because of the angle of the over hang. I did print these at 70%, so full size should be easier. I think scaling its height back up could help too.

Also I printed the saucer with no support. (and it