Thingiverse
Rasierpinselständer 2.0 (Razor and shaving brush holder)
10
Downloads
6
Likes
0
Makes
I made a shaving brush and old school safety razor holder.
The version that you see on the picture was printed before I made some extra minor tweaks.
The construction is made with structural strength in mind so I don't think it needs much infill (I printed with 10% grid), however it might stand better with a bit more weight - So it's your choice.
Cura 3.0.3 does a much better job at generating supports for this one then S3D 4.0.
I only get a small support artifact on the sides (Can som
The version that you see on the picture was printed before I made some extra minor tweaks.
The construction is made with structural strength in mind so I don't think it needs much infill (I printed with 10% grid), however it might stand better with a bit more weight - So it's your choice.
Cura 3.0.3 does a much better job at generating supports for this one then S3D 4.0.
I only get a small support artifact on the sides (Can som
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in