Thingiverse
E3D V6 split fan shroud
by Old-Steve
30
Downloads
12
Likes
0
Makes
I combined a 30mm fan duct with a filament cooler duct.
I am taking about one third of the air from the heat sink and diverting it to the filament on the bed. I wanted to minimize the weight on my effector and I wanted to cool the heat sink and the printed material with one fan.
I got tired of this thing breaking when I snap it on and off so I added a rib on the sides for some extra strength.
There is a tiny 5mm brim - trim away post print.
And the screw holes for the fan should be drille
I am taking about one third of the air from the heat sink and diverting it to the filament on the bed. I wanted to minimize the weight on my effector and I wanted to cool the heat sink and the printed material with one fan.
I got tired of this thing breaking when I snap it on and off so I added a rib on the sides for some extra strength.
There is a tiny 5mm brim - trim away post print.
And the screw holes for the fan should be drille
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in