Thingiverse
25mm based stackable warhammer mini display
9
Descargas
6
Likes
0
Makes
This is a stackable display 150 x 150 mm stand for 25mm based miniatures for D&D or Warhammer or any tabletop game. It will hold 16 of them, and they can be up to 60mm tall. (I like some headspace and clearance in my display)
I printed these with a 0.16 resolution. It will print without supports if you enable "remove holes" in Cura.
The only supports required are for the 4 holes on the bottom for the stackable feature.
The fusion file is included (it may be a mess, but you can modify the sketches). This is version 2 because I found the 5mm post holes were a little tight so I added clearance to make them stack easy.
Also, I embossed 25mm on this because it looks pretty close to the others. I have a cap for the set in another file
I printed these with a 0.16 resolution. It will print without supports if you enable "remove holes" in Cura.
The only supports required are for the 4 holes on the bottom for the stackable feature.
The fusion file is included (it may be a mess, but you can modify the sketches). This is version 2 because I found the 5mm post holes were a little tight so I added clearance to make them stack easy.
Also, I embossed 25mm on this because it looks pretty close to the others. I have a cap for the set in another file
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
