Thingiverse
A8 Spool Holder
2
Downloads
5
Likes
0
Makes
Spool Holder for Anat A8 Printer
No additional components are required for this holder. It also works very well without ball bearings.
The holder is simply pushed onto the original threaded rod and held in position by nuts.
The nuts should not be tightened too tightly. The spool must still be able to rotate easily.
Print Setup:
Material: PLA
Infill: 20 %
Nozzle: 0.4 mm
No additional components are required for this holder. It also works very well without ball bearings.
The holder is simply pushed onto the original threaded rod and held in position by nuts.
The nuts should not be tightened too tightly. The spool must still be able to rotate easily.
Print Setup:
Material: PLA
Infill: 20 %
Nozzle: 0.4 mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in