Thingiverse
RAMPS 1.4 2020 support
by sebibucky
13
Downloads
8
Likes
0
Makes
A support for the Arduino+RAMPS 1.4 stack, with a 60mm fan to keep everything cooled down.
Designed to be attached to 2020 extrusion.
V2 allows the use of 20mm corner brackets. The side arm is offset by 20mm compared to V1.
The 60mm to 80mm fan adapter allows the use of an 80mm fan. It should be printed twice, installed on the support then the fan should be attached on it.
Not printed as I do not need it, let me know if the measurements are not right.
Designed to be attached to 2020 extrusion.
V2 allows the use of 20mm corner brackets. The side arm is offset by 20mm compared to V1.
The 60mm to 80mm fan adapter allows the use of an 80mm fan. It should be printed twice, installed on the support then the fan should be attached on it.
Not printed as I do not need it, let me know if the measurements are not right.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in