Thingiverse
KitchenAid Stand Mixer Thumb Screw
by Zucky2016
54
Downloads
39
Likes
2
Makes
The thumb screw that holds the cover for attachments to our KitchenAid Classic Mixer popped apart one day when removing it for installing a meat grinder attachment, see photo.
I designed one that nearly matches the original, I had found a few others, but didn't like the basic look they had. So I came up with this one.
Printed in PLA at 0.1 mm.
To install the screw, heat it up a bit, not too much, holding it with pliers and slowly insert it into the opening, it will make a nice tight fi
I designed one that nearly matches the original, I had found a few others, but didn't like the basic look they had. So I came up with this one.
Printed in PLA at 0.1 mm.
To install the screw, heat it up a bit, not too much, holding it with pliers and slowly insert it into the opening, it will make a nice tight fi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in