Thingiverse
Filament Stand
by Mauritsio
8
Downloads
4
Likes
0
Makes
This is a lavish looking filament spool holder for up to two rolls of filament.
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT:
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in