Thingiverse
X-Axis Cable Chain for Replicator 1/CTC Bizer without connector disassembly
by kabau
45
Downloads
26
Likes
0
Makes
This is a remix of
Replicator 1 X-Axis Cable Chain by GeraldO, thing:119814
Due to glove size 12 I was not realy motivated to disassemble this micro connector at the end of the X-Axis Stepper Cable.
So I just enlarged GeraldOs thing to 15mm width.
It*s only, that it was not possible to print more than 2 chain elements at a time, due to the wide unsupported bridging distance.
But I rather prefer doing more printjobs, then disassemble micro terminals from a micro connector.
For all step
Replicator 1 X-Axis Cable Chain by GeraldO, thing:119814
Due to glove size 12 I was not realy motivated to disassemble this micro connector at the end of the X-Axis Stepper Cable.
So I just enlarged GeraldOs thing to 15mm width.
It*s only, that it was not possible to print more than 2 chain elements at a time, due to the wide unsupported bridging distance.
But I rather prefer doing more printjobs, then disassemble micro terminals from a micro connector.
For all step
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in