Thingiverse
Mode 2 Ghost Parametric Arm Guard TPU/TPE
30
Downloads
17
Likes
0
Makes
Arm guard for the awesome new Mode 2 Ghost ultralight 5' prop racing frame.
This will:
- Prevent your motor wires from being cut
- Hold down wires/esc on your arm
- not slip when printed in TPU/TPE
- require 4 cable ties
- Look clean and smooth
- hold your antennas like a boss
- print in plastic (tolerances built in)
- is parametric (adjust to any frame/esc/thickness/length desired)
Slots for 2.5mm cable ties, print right side up, so that the two sides bridge at top.
Adj
This will:
- Prevent your motor wires from being cut
- Hold down wires/esc on your arm
- not slip when printed in TPU/TPE
- require 4 cable ties
- Look clean and smooth
- hold your antennas like a boss
- print in plastic (tolerances built in)
- is parametric (adjust to any frame/esc/thickness/length desired)
Slots for 2.5mm cable ties, print right side up, so that the two sides bridge at top.
Adj
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in