CR10 X-Axis Cable Tray- No Sag

Created this to prevent the hot end wires from dragging on the bed. This was done on my S4 so not sure about the clearances at the end of the x axis for other models. Does not require disconnecting of any wires. Big enough to hold the hot end tether, Z-probe wire, and ptfe tube. I ended up not running the ptfe tube through the chain over concerns of tighter bends.

Print the new cover, base active, end swivel, washer and enough links to go in between.

Requires 1 m3x10

*I used the Rev en