Thingiverse
Cobra 88mm Frame FX805 camera mount
by Moose_Josh
0
Downloads
0
Likes
0
Makes
Camera mount for the FX805 to fit inside the Cobra 88mm Frame.
Camera hole is at 0 degrees and is a little tight so will need opening out a bit, same goes for the bracing bar holes.
V2 - removed some material at front as to not protrude onto image from the camera.
- also added some notches to the back to better fit the FX805 camera.
Camera hole is at 0 degrees and is a little tight so will need opening out a bit, same goes for the bracing bar holes.
V2 - removed some material at front as to not protrude onto image from the camera.
- also added some notches to the back to better fit the FX805 camera.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in