Thingiverse
ebike parts
by eddiema
31
Downloads
42
Likes
0
Makes
Some 3d printed parts for my ebike.
The bike is a HASA comp3.0 mountain bike fitted with a magic-pie-2 motor.
Thing one is a 3 piece junction box which clamps around the handle-bar neck. It is not IP-anything but better than leaving the wires dangling in the wind and rain.
The neck has "saga" printed on it, the neck angle is 100 degrees and the neck tubes are about 35mm OD.
The second thing is micro-switch mount to sense the brake lever home position.
Levers with switches were supplied
The bike is a HASA comp3.0 mountain bike fitted with a magic-pie-2 motor.
Thing one is a 3 piece junction box which clamps around the handle-bar neck. It is not IP-anything but better than leaving the wires dangling in the wind and rain.
The neck has "saga" printed on it, the neck angle is 100 degrees and the neck tubes are about 35mm OD.
The second thing is micro-switch mount to sense the brake lever home position.
Levers with switches were supplied
Sign in to leave a comment
Sign in