Thingiverse
Ork 'ead
by Madpig
3
Downloads
3
Likes
0
Makes
First try with SculptGL
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in