Thingiverse
Lower Suspension Arm for Helion Dominus 10TR
by Nuker9000
25
Downloads
7
Likes
0
Makes
This is for the Helion Dominus 10TR I recently crashed mine so I decided to 3D model and print a new part for it.
On a side note the hole for the pin too connect the arm to the frame was slightly small for me so I had to drill the part which wasn't too crazy. I'm not sure if its because of the model for due too the Tolerance of my printer.
On a side note the hole for the pin too connect the arm to the frame was slightly small for me so I had to drill the part which wasn't too crazy. I'm not sure if its because of the model for due too the Tolerance of my printer.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in