Nosecone Payload for BT-50 Bodytubes

I do a lot of testing with electronics for use with model rockets. To carry them I designed this nosecone.
You can select either 50mm or 80mm inside payload lengths.

For example the file "BT-50_Nosecone_Payload_Base_35mm.stl" is good for use with an 2246 - Estes® Altimeter.

If your printer is well calibrated then you should have no problems in puting the pieces together.

The coupler should be inserted in the nosecone until you measure 18mm in shoulder length. Use CA glue to keep both p