Thingiverse
Raspbeery Pi 3 magnetic mounting CR-10
by Dquantz
10
Downloads
2
Likes
0
Makes
Magnetic holder for a Raspberry Pi 3 on a CR-10
Another 3 5x5x5mm neodymium magnets are needed.
This is a remix of https://www.thingiverse.com/thing:1906310
Note that this case is still friction fit, so you may have to use a bit of force to get your Pi inside. To get your Pi back out, you can push on the board through the holes that let the power and activity LEDs shine through.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/dWTDhLbARdf
Magne
Another 3 5x5x5mm neodymium magnets are needed.
This is a remix of https://www.thingiverse.com/thing:1906310
Note that this case is still friction fit, so you may have to use a bit of force to get your Pi inside. To get your Pi back out, you can push on the board through the holes that let the power and activity LEDs shine through.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/dWTDhLbARdf
Magne
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in