Thingiverse
Yet Another X belt tensioner for the Anet A8
by lord_alan
6
Downloads
5
Likes
0
Makes
I wasn't going to publish this as it seemed a bit "meh", but someone asked me for it so here it is.
The main difference between this and the remix I sourced the idea from is the size of the block. I was unable to get my rods to fully penetrate the right hand mount so I made this with holes that allow the protrusions to fit. I also made the slot for the idler slightly wider so I could use a toothed idler that has flanges on both sides.
The OpenSCAD source is included so you can change it to
The main difference between this and the remix I sourced the idea from is the size of the block. I was unable to get my rods to fully penetrate the right hand mount so I made this with holes that allow the protrusions to fit. I also made the slot for the idler slightly wider so I could use a toothed idler that has flanges on both sides.
The OpenSCAD source is included so you can change it to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in