Thingiverse
Snapfit LED holder for Creality CR-10
by aWiseOldMan
73
Downloads
34
Likes
0
Makes
__The CR-10 was designed to print well. But that gets boring after a short while, so I recommend you step your game up: 3D printing *in the dark*__
Intended for use on the top bar, but it does work on the vertical ones (unless you actually turn the printer on and use it). It has a convenient hole and holder for the wires.
I *do not recommend* using high-powered LEDs as this model does not feature any cooling whatsoever.
Made to fit a common Chinese LED panel (40mm x 35mm)
Snap fit in
Intended for use on the top bar, but it does work on the vertical ones (unless you actually turn the printer on and use it). It has a convenient hole and holder for the wires.
I *do not recommend* using high-powered LEDs as this model does not feature any cooling whatsoever.
Made to fit a common Chinese LED panel (40mm x 35mm)
Snap fit in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in