Thingiverse
iFlight R1 X5 Rear VTX Antenna Mount
by Goz72
12
Downloads
8
Likes
0
Makes
VTX Antenna mount to suit iFlight R1 X5 frame.
Just slides over the standoffs and accepts SMA/RPSMA bulkhead mount from Immersion RC, Team Black Sheep, Matek and similar VTX's.
Printed this one in PLA and it has stood up to a few crashes where the antenna got bent well out of shape, so should be good to print up in just about any material you have on hand.
Allowed space to run the power cables out the rear of the quadcopter under the antenna mount.
It will work fine in other frames wit
Just slides over the standoffs and accepts SMA/RPSMA bulkhead mount from Immersion RC, Team Black Sheep, Matek and similar VTX's.
Printed this one in PLA and it has stood up to a few crashes where the antenna got bent well out of shape, so should be good to print up in just about any material you have on hand.
Allowed space to run the power cables out the rear of the quadcopter under the antenna mount.
It will work fine in other frames wit
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in