Thingiverse
CR-10 E3D V6 dual Extruder mount Mesh
by chips777
79
Downloads
46
Likes
0
Makes
I've meshed this E3D V6 dual extruder mount out of: https://www.thingiverse.com/thing:2182924 & https://www.thingiverse.com/thing:2274499 to fit my needs.
It's a dual extruder mount with one filament cooler and after mounting the two E3D V6 it's about the same hight as the original CR-10 Extruder.
The Hotend Cooler are from this source: https://www.thingiverse.com/thing:354723 and where a little bit redisigned for the M3 screws and this is for the stock 40mm FAN of the CR-10 (please note the
It's a dual extruder mount with one filament cooler and after mounting the two E3D V6 it's about the same hight as the original CR-10 Extruder.
The Hotend Cooler are from this source: https://www.thingiverse.com/thing:354723 and where a little bit redisigned for the M3 screws and this is for the stock 40mm FAN of the CR-10 (please note the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in