Thingiverse
TUSH spool holder/side hang/ for Makerbot rep+
by le8702
4
Downloads
5
Likes
0
Makes
https://www.thingiverse.com/thing:2494752
This original piece was done by QuantumChoco. The remix holds a TUSH spool holder on the side of the printer.
https://www.thingiverse.com/thing:2047554
link above to get-[ TUSH spool holder ]
Print settings:
Default Print modes:Draft
layer height = 0.3mm
infill density = 25%
Shells = 3
infill pattern= cat fill
support = on
This original piece was done by QuantumChoco. The remix holds a TUSH spool holder on the side of the printer.
https://www.thingiverse.com/thing:2047554
link above to get-[ TUSH spool holder ]
Print settings:
Default Print modes:Draft
layer height = 0.3mm
infill density = 25%
Shells = 3
infill pattern= cat fill
support = on
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in