Thingiverse
Jewelry / silverware hanger
by Tommyelk
10
Downloads
10
Likes
0
Makes
Jewelry / silverware hanger to hang any thing small such as a ring or a spoon while cooking.
Printing this model without support is highly not recommended. I did print it without Support and it was frustrating and it was done at the forth (4) attempt. If you will print it without support, the plastic layers will start to shrink and arch and then wrinkle at the bottom.
Printing this model without support is highly not recommended. I did print it without Support and it was frustrating and it was done at the forth (4) attempt. If you will print it without support, the plastic layers will start to shrink and arch and then wrinkle at the bottom.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in