Thingiverse
Tamiya Holiday Buggy narrowed front suspension DT-02 DT02
by eggmceye
109
Downloads
89
Likes
2
Makes
The default front suspension is a bit whacky looking due to the tread being so wide. This is a set of wishbones that drop straight in and make the tread narrower. They are fully 20mm narrower on each side!
You will need 1 new tie rod: the existing short rod can be used as the new long rod, but you'll still need a new short tie rod.
These are LHS wishbones. You can just turn them upside down for the RHS, but because the bottoms of my prints are not as nice as the top, I actually printed the
You will need 1 new tie rod: the existing short rod can be used as the new long rod, but you'll still need a new short tie rod.
These are LHS wishbones. You can just turn them upside down for the RHS, but because the bottoms of my prints are not as nice as the top, I actually printed the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in