Thingiverse
Phone / Tablet holder / stand by Kelmannen
by kelmannen
1
Downloads
0
Likes
0
Makes
A very simple and fast stand with a 4mm screwhole on the backside, i searched for it on MMF and thingiverse but couldn't find any so i made this myself instead!
the support "slot" is 29x10mm with a 2mm lip and 4mm screwhole, the total size 25x30x10 so actually it stand really good without screwing it down!
it has a left/right part but the only difference is on which side the back support is, otherwise it's the same model!
as seen on the pictures you can print it both lying down and stan
the support "slot" is 29x10mm with a 2mm lip and 4mm screwhole, the total size 25x30x10 so actually it stand really good without screwing it down!
it has a left/right part but the only difference is on which side the back support is, otherwise it's the same model!
as seen on the pictures you can print it both lying down and stan
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in