Thingiverse
Stanley Stapler Gun Spring Stop (Firing Pin Limiter)
by Z-Vert
1
Downloads
1
Likes
0
Makes
This part is for the internal mechanism of a Stanley Heavy Duty Staple Gun.
It is the part that stops the firing spring at just the right position and angle to allow it to clip back into the trigger.
The original part was made out of heavy duty rubber, but I printed this out of simple PLA and it works fine. Not too sure there is a hard enough rubber to be able to hold back the spring, so just print it in PLA or PETG.
Print Settings:
Infill: 80% (I'm sure much lower would work
It is the part that stops the firing spring at just the right position and angle to allow it to clip back into the trigger.
The original part was made out of heavy duty rubber, but I printed this out of simple PLA and it works fine. Not too sure there is a hard enough rubber to be able to hold back the spring, so just print it in PLA or PETG.
Print Settings:
Infill: 80% (I'm sure much lower would work
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in