Thingiverse
Robot Leg
by Cyril_Roudot
1
Downloads
3
Likes
0
Makes
This is a front leg , upside down. Lengthes are measured from a lamb.
The print scale is 50% for the intended hedgehog robot (visit http://violettes.org).
This is the forth release of the leg, the minimum angle range between humerus and radius is better, it comes down to 90° (see image release 16th november vs 9th, vs 3th).
It is not enough for the purpose, target is 15° is a next version, in order that the hedgehog can lay on the floor.
Les proportions de cette patte avant sont pri
The print scale is 50% for the intended hedgehog robot (visit http://violettes.org).
This is the forth release of the leg, the minimum angle range between humerus and radius is better, it comes down to 90° (see image release 16th november vs 9th, vs 3th).
It is not enough for the purpose, target is 15° is a next version, in order that the hedgehog can lay on the floor.
Les proportions de cette patte avant sont pri
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in