Thingiverse
A card-holder for little hands
by 5Byron5
20
Downloads
16
Likes
0
Makes
This is a card holder I made for my daughter.
She basically cannot handle more than afew cards and now uses this holder as additional storage.
The print is fairly standard, 195°C Extruder (PLA), 35°C the bed.
I used an infill of 15%, less is possible, more is overkill.
The width of the holder is roughly 200mm. So for smaller beds, the x-axis could be scaled to the width of the bed.
She basically cannot handle more than afew cards and now uses this holder as additional storage.
The print is fairly standard, 195°C Extruder (PLA), 35°C the bed.
I used an infill of 15%, less is possible, more is overkill.
The width of the holder is roughly 200mm. So for smaller beds, the x-axis could be scaled to the width of the bed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in