Thingiverse
Tozo RC Rim and Tires
by CSteele0514
49
Downloads
62
Likes
0
Makes
Rim and tires for a Tozo Rc car.
There are left and right tires, because the inside of the tire is flat for easier printing without support. (better for flexible filaments)
Rim and tires are approximately 1 inch wide. The Rim is 2.5 in diameter. With the tires on it makes the overall diameter just over 3.2 inches.
(Drawing included)
The Rim fits over a .285 inch hexagon.
Hole for axle is .12 in dia.
Rim printed with PLA
Tire printed with TPU
There are left and right tires, because the inside of the tire is flat for easier printing without support. (better for flexible filaments)
Rim and tires are approximately 1 inch wide. The Rim is 2.5 in diameter. With the tires on it makes the overall diameter just over 3.2 inches.
(Drawing included)
The Rim fits over a .285 inch hexagon.
Hole for axle is .12 in dia.
Rim printed with PLA
Tire printed with TPU
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in