Thingiverse
iPhone PLUS or X car holder with charger
by b03tz
25
Downloads
26
Likes
0
Makes
This iPhone holder can be printed with the charger cable embedded in it.
The process goes as following: let it print until the last layer where it would bridge the charger part and stick your cable in there. I taped it down on the center part that's already printed and held it until 2 layers were printed.
After printing you'll notice the cable fits a bit loose. What I did is scuffing the charger cable plastic (because it's really smooth) and filled the pocket with glue then pushed it back
The process goes as following: let it print until the last layer where it would bridge the charger part and stick your cable in there. I taped it down on the center part that's already printed and held it until 2 layers were printed.
After printing you'll notice the cable fits a bit loose. What I did is scuffing the charger cable plastic (because it's really smooth) and filled the pocket with glue then pushed it back
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in