Thingiverse
Mini lathe compound bearing upgrade
by Rainbows871
112
Downloads
67
Likes
0
Makes
Made for my CJ18A minilathe, will probably fit most asian 7" swing machines.
The dial lock will require a M10 thread being tapper through the bore. Using a countersink to chamfer the ends really helps to keep the tap true.
You also need to drill and tap two M3 holes, about 10mm deep. 39mm apart and 3.5mm down from the top of the compound slide upper, hole should be 5mm from the edges of the compound. There is also a drilling jig to help you line your holes up, works best in a drill press (
The dial lock will require a M10 thread being tapper through the bore. Using a countersink to chamfer the ends really helps to keep the tap true.
You also need to drill and tap two M3 holes, about 10mm deep. 39mm apart and 3.5mm down from the top of the compound slide upper, hole should be 5mm from the edges of the compound. There is also a drilling jig to help you line your holes up, works best in a drill press (
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in