Thingiverse
Hobby Lobby Hunter/Tornado electronics & steering mounts
by bummster
6
Downloads
13
Likes
0
Makes
WIP
Printed everything up and it all fits pretty darn well. Won't know for sure until I fit the engine and exhaust. The front bell cranks may also get adjusted if I run into clearance issues with a center driveshaft pillow block on a 4x4 model.
* Rearrangement of the radio gear and steering setup for a Hobby Lobby Hunter.
* Uses stock mounting holes. (at least the holes that were on my test chassis, YMMV)
* Radio box is sized to fit a Tower Hobbies 224 receiver and a 6V receiver batter
Printed everything up and it all fits pretty darn well. Won't know for sure until I fit the engine and exhaust. The front bell cranks may also get adjusted if I run into clearance issues with a center driveshaft pillow block on a 4x4 model.
* Rearrangement of the radio gear and steering setup for a Hobby Lobby Hunter.
* Uses stock mounting holes. (at least the holes that were on my test chassis, YMMV)
* Radio box is sized to fit a Tower Hobbies 224 receiver and a 6V receiver batter
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in