Thingiverse
Cover for 12V / 20A Chinese Power Supply S250-12
by kschoelpple
2
Downloads
3
Likes
0
Makes
Got myself one of those Prusa -i3 Chinese made printers. (Just starting with 3D printing stuff)
Found power supply had no cover which makes it rather dangerous from an electrical safety point of view. Appears there are many versions out there but couldn't find anything suitable for my S250-12 power supply. (only about 97mm wide). So, this is my first real 3D design. Not fancy but gets the job done. - Better safe than sorry.
Cover simply screws into the side of power supply. Rear left open fo
Found power supply had no cover which makes it rather dangerous from an electrical safety point of view. Appears there are many versions out there but couldn't find anything suitable for my S250-12 power supply. (only about 97mm wide). So, this is my first real 3D design. Not fancy but gets the job done. - Better safe than sorry.
Cover simply screws into the side of power supply. Rear left open fo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in