Thingiverse
M5, M4 and M3 nut and washer adaptors for 2020 extrusions.
by brunofporto
54
Downloads
43
Likes
0
Makes
This is a nut and washer holder for 2020 extrusions. Specially the Brazilian ones that have 8mm groove and are not compatible with standard T-Nuts from china.
The mechanical stress is held by the washer and the printed component only acts as a nut holder so you can tight it.
The M5 versions needs a DIN-439 (thinner) nut to fit inside the extrusion.
All versions uses M5 washers. The M3 version also uses one M3 washer to interface with the M5 washer.
Updates:
Modified the M4 version to
The mechanical stress is held by the washer and the printed component only acts as a nut holder so you can tight it.
The M5 versions needs a DIN-439 (thinner) nut to fit inside the extrusion.
All versions uses M5 washers. The M3 version also uses one M3 washer to interface with the M5 washer.
Updates:
Modified the M4 version to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in