DIY Prusa i3 x-end-idler and -motor for anit-backlash T8 brass nut

This is a modification to Prusa's original MK2s x-end-idler and x-end-motor carriage mounts to fit the T8 Anti-backlash Brass Nut.

I tried to keep the # of file changes to a minimum, so only the 2 scad files, x-end-idler and x-end-motor, were modified.

This requires you to hacksaw 2 of the 4 mounting holes on the brass nut, to make them into open slots.

The opening on the x-end carriage for the brass nut is 12mm diameter to accommodate the anti-backlash spring+the brass nut.

I took