Dial Gauge Adapter For Taz 3-5

(see https://www.thingiverse.com/thing:2699619 for a Taz 6 version)
I just created this dial gauge adapter for leveling the Z axis (X carriage guides) on Taz 3-5 machines.
Makes it a lot easier. I had been using a digital caliper, but it was not very accurate and I was never sure if it was plumb, etc.
This one clips over the top guide rail, and swings onto the lower rail. There is a small hole for a 1/16" (1.5mm) pin, but you probably won't need to use it. The bottom clip curves and tighte