Thingiverse
D-BOT Shortened Z Axis Motor Mounts
by curlypaul
31
Downloads
11
Likes
0
Makes
I needed to either shorten my leadscrews a bit or lower my z motors
As I'm only using short 34mm motors, I had the room to lower them
updated to Rev2, these now have the M5 Counterbores 'covered' to allow for printing without supports
Three designs 8, 10 and 16mm shorter
As I'm only using short 34mm motors, I had the room to lower them
updated to Rev2, these now have the M5 Counterbores 'covered' to allow for printing without supports
Three designs 8, 10 and 16mm shorter
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in