Thingiverse
Milwaukee M12 Battery Cap
by pantonvich
42
Downloads
22
Likes
0
Makes
Cap for Milwaukee M12 Battery
After you print the cap - it's best the stuff the battery into it while it's still warm to get a good fit. If it's cooled down use a heat gun to carefully warm the area - it doesn't take a lot of heat - and stuff the battery into the cap a few times - reheat the cap a few times if needed.
If the latch/clip arms don't align correctly with the base tabs you can soften the cap arms up a bit and twist them into place and toe them in for better contact with the bas
After you print the cap - it's best the stuff the battery into it while it's still warm to get a good fit. If it's cooled down use a heat gun to carefully warm the area - it doesn't take a lot of heat - and stuff the battery into the cap a few times - reheat the cap a few times if needed.
If the latch/clip arms don't align correctly with the base tabs you can soften the cap arms up a bit and twist them into place and toe them in for better contact with the bas
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in