Thingiverse
Prusa i3 MK2 - Linear Advance Calibration
by 3druck_com
48
Downloads
25
Likes
0
Makes
Two testfiles that allow you to callibrate Linear Advance for your Prusa i3 MK2 3D-Printer.
For using Linear Advance you will need the so calles "K-Factor", deppending on your Material the needed factor will be between 0 and 100. For PLA good values are between 35 and 50.
The test files will creates a few lines in ascending order. Both files start with a K value of 0 and then a step size of 5 or 10 (depending on the used file). The whole test only works with the the most recent firmware,
For using Linear Advance you will need the so calles "K-Factor", deppending on your Material the needed factor will be between 0 and 100. For PLA good values are between 35 and 50.
The test files will creates a few lines in ascending order. Both files start with a K value of 0 and then a step size of 5 or 10 (depending on the used file). The whole test only works with the the most recent firmware,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in