Thingiverse
Wall Mounted Filament Rack and Dispenser
by customlifeco
23
Downloads
20
Likes
0
Makes
A remix of https://www.thingiverse.com/thing:1047639
Changes and improvements
1. Shortened up the wall brackets and carriages. My spools would not fit in the original without rubbing. Also, my ANET A8 print bed is not large enough to print the original wall brackets.
2. Added a center bracket as I noticed some sagging when fully loaded.
3. Added bottom guides in the bearing slots to keep them from falling through when trying to install the carriages.
4. Created a filament guide as I wante
Changes and improvements
1. Shortened up the wall brackets and carriages. My spools would not fit in the original without rubbing. Also, my ANET A8 print bed is not large enough to print the original wall brackets.
2. Added a center bracket as I noticed some sagging when fully loaded.
3. Added bottom guides in the bearing slots to keep them from falling through when trying to install the carriages.
4. Created a filament guide as I wante
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in