Thingiverse

Silicone tube based corner mounts for Lulzbot Taz 1-5 and Aluminum bed plates

by piercet

8 Downloads

6 Likes

0 Makes

Download Model

This project allows you to use silicone rubber fuel tubing in place of your springs. The tube I am using was intended for a chain saw, and is about 1/4" in diameter. You need 4 identically cut tube lengths about the same length as the stock springs, several M3 heat set inserts, and the stock M3 mounting hardware and bed retention fingers. You may need slightly longer M3 bolts depending on the final length of your tubing.

Instructions. Print from ABS (PLA will melt here) then remove the integ

Source

Thingiverse

Comments

Makes