Thingiverse
270° Hinge Adjustable Position
door thaina128
78
Downloads
80
Likes
0
Makes
This is a print-in-place hinge 60 x 40 mm (2.4 x 1.6") Adjustable Position 4 mm thick.
You can adjust the position after you make the holes.
I used on my Ender 3 enclosure.
Horizontal Expansion -0.2
Then check layer 27 if the space between the "pins" is enough and will not melt together.
80% infill has a very good strength
You can adjust the position after you make the holes.
I used on my Ender 3 enclosure.
Horizontal Expansion -0.2
Then check layer 27 if the space between the "pins" is enough and will not melt together.
80% infill has a very good strength
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
