Thingiverse
Ikea Gallant Hanger v2
by bpmarkowitz
6
Downloads
3
Likes
0
Makes
Remix of my original Ikea Gallant desk hanger. The legs are around 45mm in diameter.
This version prints as two parts: the strap that goes around the leg, and the peg which attaches.
I print the peg upright (hole up, flat side down) at 100% infill. Layer height up to you.
For the strap, you will need to use supports. I use 100% infill on this also for added durability.
The fit between the peg and the strap is really nice and snug. You may need to use a rubber mallet or something sim
This version prints as two parts: the strap that goes around the leg, and the peg which attaches.
I print the peg upright (hole up, flat side down) at 100% infill. Layer height up to you.
For the strap, you will need to use supports. I use 100% infill on this also for added durability.
The fit between the peg and the strap is really nice and snug. You may need to use a rubber mallet or something sim
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in