Thingiverse
Cable Chain Ends for Felix 3D Printer
30
Downloads
25
Likes
0
Makes
If you like what you see here, consider leaving a tip.
End pieces for a Felix Printer upper cable chain. The ends were matched with a 10 x 15 mm R18 drag chain that was purchased on amazon for $14 Canadian. This was inspired by a project that a friend suggested I check out which can be found here. I hope to have a cable chain design completed for the print bed wires sometime soon.
Using this chain will require routing all wires from the print head toward the rear of the printer. I disc
End pieces for a Felix Printer upper cable chain. The ends were matched with a 10 x 15 mm R18 drag chain that was purchased on amazon for $14 Canadian. This was inspired by a project that a friend suggested I check out which can be found here. I hope to have a cable chain design completed for the print bed wires sometime soon.
Using this chain will require routing all wires from the print head toward the rear of the printer. I disc
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in