Thingiverse
GoPro HERO Session 21° Wedge-mount
22
Downloads
23
Likes
0
Makes
A simple 21-degrees ascent to replace a foam wedge on miniquads.
It provides an imprint of the camera and therefore a better alignement for the GoPro HERO Session series (HERO/HERO4/HERO5).
The strap can run under the topplate as with classic foam wedge fittings or threaded through the slot if the wedge is mounted with zip ties through the provided grooves.
The width at the bottom is 34 mm and should be slim enough to fit most of the quads - even the ones with narrower top plates like the I
It provides an imprint of the camera and therefore a better alignement for the GoPro HERO Session series (HERO/HERO4/HERO5).
The strap can run under the topplate as with classic foam wedge fittings or threaded through the slot if the wedge is mounted with zip ties through the provided grooves.
The width at the bottom is 34 mm and should be slim enough to fit most of the quads - even the ones with narrower top plates like the I
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in